Slide-Lok Clamps
Levers on the Slide-Lok Clamp must be in full upright position for the rope to slide freely back and forth.
Sizes available: 3/8”, 1/2” and 5/8”
(The 3/8” slide-lok has flanges attached to the cams to be sure the 3/8” cordage will not slide out.)
Load rope from the side, being sure arms on slide-lok are in the upright position. When clamping arms down to lock into position, make sure to press the arms forward and down to snap in place.
Made for all types of ropes.
Ties up that Jet Ski to anchor lines with a snap!
Looks nice and works good!
For 3/8” size to 1/2” size, slid-lok clamp tensile strength is 2,400 lbs.
Note: This is breaking lb. Test. Use a working load of 10%.
Example: 2,400 X 10% equals 240. Your approximate working load limit would be 240 lbs.
5/8” slide-lok clamps work on 9/16” - 5/8” size rope.
Tensile strength is 3,500 lbs. Your approximate working load limit would be 350 lbs.
Levers on the Slide-Lok Clamp must be in full upright position for the rope to slide freely back and forth.
Sizes available: 3/8”, 1/2” and 5/8”
(The 3/8” slide-lok has flanges attached to the cams to be sure the 3/8” cordage will not slide out.)
Load rope from the side, being sure arms on slide-lok are in the upright position. When clamping arms down to lock into position, make sure to press the arms forward and down to snap in place.
Made for all types of ropes.
Ties up that Jet Ski to anchor lines with a snap!
Looks nice and works good!
For 3/8” size to 1/2” size, slid-lok clamp tensile strength is 2,400 lbs.
Note: This is breaking lb. Test. Use a working load of 10%.
Example: 2,400 X 10% equals 240. Your approximate working load limit would be 240 lbs.
5/8” slide-lok clamps work on 9/16” - 5/8” size rope.
Tensile strength is 3,500 lbs. Your approximate working load limit would be 350 lbs.